BioRUST Forums - View Single Post - Layer Styles

Zac3010 · 06-10-2004

Hey all, I was doing a pratice animation where I had a shiney smiley face that had his tounge stick out. What I did to do this was take a circle and cut it into two, so that the tounge layer could slide under the uper half of the circle so that it would apear as if it were going in his mouth. I was wondering if anyone knew of a way of distributing the layer style properties of both the top and bottom half of the circle layer so that the shiney effect would look like its acting on only one layer. Thank you all for your help. I'm certinally not a PSCS n00b, so I don't mind if you get complicated on me.

06-10-2004	#1 (permalink)
Zac3010 Registered User Join Date: Jun 2004 Posts: 10	Layer Styles - How to spread evenly over two layers? Hey all, I was doing a pratice animation where I had a shiney smiley face that had his tounge stick out. What I did to do this was take a circle and cut it into two, so that the tounge layer could slide under the uper half of the circle so that it would apear as if it were going in his mouth. I was wondering if anyone knew of a way of distributing the layer style properties of both the top and bottom half of the circle layer so that the shiney effect would look like its acting on only one layer. Thank you all for your help. I'm certinally not a PSCS n00b, so I don't mind if you get complicated on me. Last edited by Zac3010; 06-10-2004 at 01:00 AM..